Product ID:THERMOFIT S-1006 ADHESIVE PART B
MSDS Date:11/01/1995
FSC:8040
NIIN:00-109-8101
Status Code:A
MSDS Number: CJPBC

Emergency Phone: 800-424-9300

Info Phone: 650-361-4907

Preparer: LINDA MASSEY

Cage: 06090

Telephone: 415-361-4907

Cage: 06090

AMINES, POLYETHYLENEPOLY-, REACTION PRODUCTS WITH

CAS: 68410-23-1

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYE CNTCT: THIS MATL IS SEVERE
EYE IRRIT. DIRECT CNTCT W/LIQ/EXPOS TO VAP/MIST MAY CAUSE STINGING,
TEARING, REDNESS, & SWELLING. PERS W/PRE-EXISTING EYE DISORDERS MAY
BE MORE SUSCEPTIBLE TO EFT S OF THIS MATL. SKIN: THIS MATL MAY
CAUSE MILD SKIN IRRIT. PROLONGED/REPEATED CONTACT OR EXPOSURE TO
VAPORS/ MIST MAY CAUSE REDNESS AND BURNING. PERSONS WITH
PRE-EXISTING SKIN DISORDERS MAY BE MORE SU SCEPTIBLE TO THE EFFECTS
OF THIS MATEIRAL. CONTACT MAY RESULT IN SKIN ABSORPTIONBUT SYMPTOMS
OF TOX ARE NOT ANTICIPATED BY THIS ROUTE ALONE UNDER NORMAL
CONDITIONS OF USE. (EFTS OF OVEREXP)
Explanation of Carcinogenicity:THE INGREDIENTS OF THIS PRODUCT, PRESENT
OR EQUAL TO OR GREATER THAN 0.1% OF THE PRODUCT, ARE NOT LISTED BY
OSHA, NTP, OR IARC AS SUSPECT CARCINOGENS.
Effects of Overexposure:HLTH HAZ: INGEST: THIS MATL MAY BE FATAL OR
HARMFUL IF SWALLOWED. INGESTION MAY RESULT IN SEVERE IRRITATION AND
BURNS OF THE MOUTH, THROAT, AND DIGESTIVE TRACT. INHAL: EXPOSURE
TO VAPORS OR FUMES MAY CAUSE IRRITATION OF THE RESP TRACT.
CHRONIC: A COMPONENT OF PART B (POLYAMIDE RESIN) IS ALSO SUSPECTED
OF BEING ABLE TO CAUSE CHANGE IN THE GENETIC MATERIAL (DNA) OF A
CELL. WHAT THESE FINDINGS MEA N TO HUMANS IS UNCERTAIN. COMMENTS:
OVERHEATING MATL (OTHER INFO)
Medical Cond Aggravated by Exposure:PRE-EXISTING LUNG DISORDERS (E.G.
ASTHMA-LIKE CONDITIONS) MAY BE AGGRAVATED BY EXPOSURE TO THIS MATL.

First Aid:EYES: HOLD EYELIDS APART & FLUSH AFFECTED EYE(S) IMMED
W/CLEAN H*2O FOR AT LEAST 15 MIN. SEEK IMMED MED ATTN. SKIN: FLUSH
W/PLENTY OF H*2O & WASH AFFECTED AREA(S) W/SOAP & H*2O. REMOVE
CONTAMD CLTHG & WASH BEFORE REUSE. THOROUGHLY CLEAN SHOES BEFORE
REUSE. CONTAMD LEATHER ARTICLES, INCLUDING SHOES, CANNOT BE
DECONTAMINATED & SHOULD BE DESTROYED TO PVNT REUSE. IF IRRIT
PERSISTS, SEEK MED ATTN. IF C NTCT W/PROD OCCURS, IMMED FLUSH
W/COOL H*2O FOR 15 MIN. CAREFULLY REMOVE CLTHG,IF CLTHG IS STUCK TO
A BURNED AREA DO NOT PULL IT OFF, BUT CUT AROUND IT. COVER BURNED
AREA W/CLEAN MATL & SEEK MED ATTN IMMED. (OTHER INFO)

Flash Point Method:OC
Flash Point:>185.C, 365.F
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . USE WATER SPRAY TO COOL NEARBY CONTAINERS AND
STRUCTURES EXPOSED TO FIRE. DO NOT USE SOLID STREAM APPLIANCE.
Unusual Fire/Explosion Hazard:TOXIC FUMES MAY BE GIVEN OFF IN A FIRE.
SEE SECTIONS ON THERMAL DEGRADATION AND COMBUSTION BYPRODUCTS AND
OTHER PRECAUTIONS.

Spill Release Procedures:WEAR APPROPRIATE PERSONAL PROTECTION WHEN
RESPONDING. CONTAIN SPILL WITH INERT ABSORBENT. TAKE MEASURES TO
STOP SPILLAGE AT THE SOURCE. TRANSFER CONTAMINATED ABSORBENT INTO A
CONTAINER AND DISPOSE IN ACCORDANCE TO LOCAL, STATE AND FEDERAL
LAWS. WASH AREA WITH DILUTE (5%) ACETIC, ACID, PICKUP WITH INERT
ABSORBENT AND DISPOSE OF PROPERLY.

Handling and Storage Precautions:AVOID CONT W/EYES, SKIN/CLOTHING.
CONTAMD LEATHER ARTICLES, INCLUDING SHOES, CANNOT BE DECONTAMD &
SHOULD BE DESTROYED TO PRVNT REUSE. AVOID BREATHING VAPORS/MIST.
APPLIC OF ADHESIVE (PARTS A &B) SHOU LD BE DONE IN A WELL-VENTD
AREA. STOREIN COOL,DRY AREA. KEEP AWAY FROM OPEN FLAMES & HIGH
TEMPS.
Other Precautions:CONTAINERS, EVEN THOSE HTAT HAVE BEEN EMPTIED, CAN
CONTAIN HAZARDOUS PRODUCT RESIDUES. HANDLE IN ACCORDANCE WITH
PRECAUTIONS OUTLINED IN THE HANDLING SECTION ABOVE. PART A& B
RELEASE HEAT WHEN COMBINE D. PROTECT PACKETS FROM PHYSICAL DAMAGETO
AVOID LEAKS AND SPILLS. KEEP CNTNR CLSD.

Respiratory Protection:DEPENDING ON THE AIRBORNE CONCENTRATION OF
MATERIAL, USE A NIOSH APPROVED AIR PURIFYING RESPIRATOR WITH
ORGANIC VAPOR CARTRIDGES. AT TEMPERATURES ABOVE 300F (149C)
HAZARDOUS THERMAL DEGRADATION PRODUC TS MAY BE RELEASED. THEREFORE,
IF TEMPERATURES EXCEED 300F (149C), AIR-SUPPLIED RESPIRATORS ARE
RECOMMENDED.
Ventilation:IN ACCORDANCE WITH GOOD INDUSTRIAL HYGIENE PRACTICE, ENSURE
ADEQUATE VENTILATION DURING APPLICATION.
Protective Gloves:RUBBER GLOVES TO PRVNT/MIN CONTACT.
Eye Protection:ANSI APPROVED CHEMCIAL WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH AND DELUGH SHOWER .
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING. REMOVE
CONTAMINATED CLOTHING AND SHOES. WASH CONTAMINATED CLOTHING BEFORE
REUSE. THOROUGHLY CLEAN SHOES BEFORE REUSE.
Supplemental Safety and Health

Spec Gravity:0.97 (WATER =1)
Solubility in Water:1-10%
Appearance and Odor:TAN LIQUID. ODOR OF AMMONIA.
Percent Volatiles by Volume:0 @ 70F

Stability Indicator/Materials to Avoid:YES
PART B: NONE KNOWN.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT FOR PROLONGED PERIODS
OF TIME.
Hazardous Decomposition Products:THERMAL DEGRADATION & COMBUSTION
BYPRODUCTS: THERMAL DEGRADATION & COMBUSTION BY PROD MAY BE TOX &
SHOULD NOT BE INHALED. THERMAL DEGRADATION IS NOT SIGNIFICANT AT
TEMP ACHIEVED DURING (TOX INFO)
Conditions to Avoid Polymerization:HAZ POLYMERIZATION WILL NOT OCCUR,
POLYMERIZATION MAY OCCUR ABOVE 500F. SOME CURING AGENTS, EG, (TOX
INFO)

Waste Disposal Methods:THIS PRODUCT IS A NON-HAZARDOUS WASTE IN
ACCORDANCE WITH U.S. EPA REGULATIONS. CLASSIFICATION ACCORDING TO
ALL FEDERAL, LOCAL AND STATE HAZARDOUS WASTE REGULATION IS REQUIRED
BEFORE DISPOSAL.

Toxicological Information:POLYM CNDTNS: ALIPHATIC POLYAMINES CAN
PRODUCE EXOTHERMIC REACTIONS WHICH IN LARGE MASSES CAN CAUSE
RUNAWAY POLYMERIZATION AND CHARRING OF REACTANTS. HAZ DECOMP PROD:
PROPER APPLIC, AS DIRECTED BY PRO D INSTRUCTIONS. AT TEMPS ABOVE
300F ORMOST SIGNIFICANTLY IF THE PRODUCTS ARE BURNED, THE THERMAL
DEGRATATION AND COMBUSTION BYPRODUCTS MAY INCLUDE, BUT ARE NOT
LIMITED TO, CARBON MONOXIDE, AMMONIA, AL DEHYDES, ACIDS AND OTHER
ORGANIC SUBSTANCES AND OXIDES OF NITROGEN.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Transport Information:DOT PROPER SHIPPING NAME; DOT IDENTIFICATION NO.;
DOT HAZARD CLASSIFICATION: NOT REGULATED.

Federal Regulatory Information:TSCA INVENTORY STATUS: ALL INGREDIENTS
ARE LISTED.
State Regulatory Information:OTHER INFO: SEEK IMMED MED ATTN. IF
VICTIM IS NOT BREATHING, IMMED BEGIN ARTIFICIAL RESPIRATION. KEEP
VICTIM WARM AND QUIET, SEEK IMMED MED ATTN.